1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
|
include <parameters.scad>
use <nipple.scad>
use <rail.scad>
module half() difference() {
union() {
// upper horizontal bar
translate([0, 0, tray_height - bar_thickness])
cube([tray_width / 2, bar_thickness, bar_thickness]);
// vertical bar
cube([bar_thickness/2, bar_thickness, tray_height]);
// lower horizontal bar
cube([bar_thickness/2 + rail_width + pla_epsilon, bar_thickness, bar_thickness]);
// vertical thread bold receiver
translate([0, bar_thickness, tray_height-bar_thickness]) cube([bar_thickness/2, bar_thickness, bar_thickness]);
translate([tray_width/2 - bar_thickness, bar_thickness, tray_height-bar_thickness]) cube([bar_thickness, bar_thickness, bar_thickness]);
// male downward positioning nippel
translate([rail_width, bar_thickness / 2, 0]) nipple();
}
// receiver for rail
translate([bar_thickness/2 - rail_thickness, 0, bar_thickness - rail_thickness])
rail();
// holes for thread rods (horizontal, vertical)
translate([0, bar_thickness / 2, 0])
cylinder(h = tray_height, r = (rod_diameter + pla_epsilon) / 2, $fs=0.1);
translate([0, bar_thickness * 1.5, tray_height - bar_thickness / 2]) rotate([0, 90, 0])
cylinder(h = tray_width / 2, r = (rod_diameter + pla_epsilon) / 2, $fs=0.1);
// hole for nut on the bottom of the vertical rod
translate([0, bar_thickness / 2, 0])
cylinder(h=nut_height, r=nut_diameter/2 + pla_epsilon, $fs=0.1);
// female downward positioning nippel
translate([rail_width, bar_thickness / 2, tray_height]) nipple(pla_epsilon);
}
difference() {
union() {
half();
mirror() half();
}
// female leftward positioning nippel
# translate([-tray_width/2, bar_thickness / 2, tray_height - bar_thickness / 2]) rotate([0, 270, 0]) nipple(pla_epsilon);
}
// male rightward positioning nippel
translate([tray_width / 2, bar_thickness / 2, tray_height - bar_thickness / 2]) rotate([0, 270, 0]) nipple();
|
